We've lived with the compactor as a trash can. Remove the drawer from the cabinet and clean the tracks and rollers with a mild detergent or degreaser.
Use a screwdriver or ratchet with screwdriver attachment to remove the door to the trash compactor.
Kitchenaid garbage compactor stuck. Look in the garbage itself and remove all of the excess. If you compactor will not operate or turn on, there are a few things to try before calling for service. Identify the hex socket on the center of the underside of the garbage disposal unit.
Remove the trash compactor door. 5% coupon applied at checkout. To ensure the ram is raised all the way follow the below instructions:
Our kitchenaid kucc151 trash compactor makes a loud whining noise when you turn it on, and the door won't open when it's off. Pull the trash compactor out Our trash compactor hadn't worked right for the past 2 years.
Remove any such items that could hinder the metal ram from moving. Avoid spilling liquids if possible. To inspect the power nuts, remove the trash compactor from the cabinets and disconnect the power.
Models with push button controls: 365 days to return any part. Food spills inside the trash compactor drawer can build up on the slide and rollers.
Whether your trash compactor won’t start or your trash compactor makes noise, call us. Open the top of the trash compactor and remove the bin. Did you press on before pressing start?
Some models have to be turned to the on position before it will operate. Remove compactor drawer remove screws holding compactor to counter screw in adjustable feet a short distance slide compactor out far enough to unplug loosen top screws that hold tiedown strips and move tie down strips out of way remove two phillips screws on control panel push control panel assymbly up and out of front of compactor If your compactor turns on via foot pedal, pull out the drawer and make sure the foot pedal mounting screws are tight.
When we pulled out the drawer there was nothing stuck in the back, sides or top to prevent it from latching closed. Free returns on major appliances 1. It sounds like the ram is stuck down, and can't pull it back up so the doo …
If your ram is getting stuck, if there is excess noise during operation, or if your compactor does not stop at the end of the compacting cycle you may have an issue with your drive gear. 0% apr financing available 2. If you can't manually lift the ram and the container is full of trash, carefully tilt the trash compactor forward and remove the bottom panel.
At lake appliance repair, we service all the most popular trash compactor brands and models. The drawer is likely partially open often caused by trying to crush bottles and it tips to one side. Turn the power off to the trash compactor before you begin its removal.
Trash compactor is hard to open. And when you add a home trash compactor with odor management you'll discover more efficient waste removal process that keeps your kitchen smelling fresh. Completely dry the components, then apply a household lubricant to the tracks and rollers to keep them moving freely.
The drawer will open only when the ram is fully raised. If the ram is stuck in a down position, open the bottom panel and check the drive gear. Insert the hex wrench into this socket, then move the wrench back and forth to free the jam or confirm that the impeller is freed.
Open 7 days a week. Common solutions (4) common solutions for: We've had 2 appliance repairman out to fix it.
Usually, if the latch is broken, you can use a putty knife or screwdriver to release the door catch. My kitchenaid trash compactor is stuck in the closed position and is not completing its cycle. This will make it easier to pull the trash compactor out without having the door fly out at you.
When you notice your trash compactor not working, it can really throw off your routine. Free returns on major appliances 1. Press off, and then press on.
Some have a switch around the front panel. Pay over time with affirm. Take off the mounting brackets and remove the top panel.
Look inside the trash compactor for garbage that was pushed out of the garbage bin. After removing the drawer, inspect the latch. But that is supposed to reverse it if the front switch is closed.
They were unable to fix it. Erase any trace of your latest masterpiece with trash compactors that reduce waste volume by 80% and garbage disposal units that can handle your toughest ingredients. With an upgrade to a kitchenaid ® food waste disposer, you'll discover a quiet appliance with constant grinding power to cut through tough foods types.
Press the on button before pressing start (on some models). Kitchenaid trash compactor drawer will not open. You may have to disassemble the drawer to remove.
At the very back end of the drawer are two extensions that go back and hit a switch that shut it off. Check that the activator lever is coming into contact with the switch. Had to unplug it … read more
See all garbage disposers & compactors | kitchenaid. Put everything back and start the trash compactor. Original, high quality parts for kitchenaid kcs100a / compactor in stock and ready to ship today.
It's inside a small, round hole in the motor housing. Reassemble the trash compactor after finding and fixing the failure that caused the ram to stick in the down position. If the power nuts become stripped or damaged, the ram may become stuck and you will often hear a loud banging noise as well.
Plug the trash compactor back in and reinstall the compactor in the cabinet. On major appliance orders $399+ 3. Kitchenaid trash compactor will not operate.
To troubleshoot the trash compactor, disconnect the power source and remove the unit from your cabinets. The gear is made of plastic, is white in color, is sold individually, and is approximately 4.75 in diameter. Remove the mounting brackets and the top panel for a visual inspection.
Request within 15 days for a product return. 4.1 out of 5 stars. Our reno trash compactor repair techs can diagnose and fix the problem fast.
If the ram is stuck in the down position you may need to lay the unit on its side and go through the bottom first, rotating the drive gear to lift the ram back up.